Electronics TSP-M, Instruction Manual

Page: 11 / 24

Electronics Inc. • (574) 256-5001 • www.electronics-inc.com 11
Checking or Setting the Spindle Starting Position
To evaluate the Spindle Starting Position, place the Zero Block on the gage and enter the gage into True Spindle
Mode by pressing and holding the ZERO/ON button for three (3) seconds (the “X1” will disappear when in True
Spindle Mode). The value of the Spindle Starting Position should be set to 0.000 mm + 0.025 mm (0.0000 inch +
0.0010 inch). If the Spindle Starting Position is out of tolerance, reposition the indicator on the frame using the
instructions below or call Electronics Incorporated or an Authorized Distributor for assistance.
Instructions :
Be sure the zero indicator block is in place and then loosen the 8 mm gland nut holding the indicator. Adjust the
indicator placement on the frame until the Spindle Starting Position is within tolerance. Carefully tighten the gland
nut and be sure the indicator is secure. It should not move or rotate, and the Spindle Starting Position should not
change as the gland nut is tightened. Place a dab of proof lacquer at the gland nut and stem as a tamper-proof
seal.
Contacting Electronics Inc.
Mailing and Shipping Address:
Electronics Inc.
56790 Magnetic Drive
Mishawaka, IN 46545 USA
Telephone: 1-800-832-5653 (Toll-free in USA and Canada) or (574) 256-5001
Fax: (574) 256-5222
Email: sales@electronics-inc.com
Website: www.electronics-inc.com