6
TARGET TORQUE INDICATION
The DTL torque wrench will alert you to reaching 90% of the target value
by an audible beep and a green LED light. When you reach 100% the
beep will change to a steady tone. When the torque applied is greater
than the target a red light will illuminate above the green.
MAINTENANCE AND STORAGE
1. Do not Over-torque (105% of Max. torque capacity). Over-torqueing
can damage torque wrench or cause it to lose accuracy.
2. If Er0 is displayed when the wrench is powered on, it indicates that it
has been overloaded and should be returned to the factory for
service.
3. Remove battery when storing for long period of time.
4. Do not use this torque wrench as a hammer.
5. Do not expose to excessive heat, humidity, or direct sunlight.
6. Do not use the torque wrench near water.
7. If the torque wrench gets wet, wipe it with a dry towel as soon as
possible. The saltwater can be especially damaging.
8. Do not use organic solvents, such as alcohol or paint thinner when
cleaning the torque wrench.
9. Keep this torque wrench away from magnets.
10. Do not expose this torque wrench to dust or sand as this could cause
serious damage.
11. Do not apply excessive force to the LCD panel.
3
SPECIFICATIONS
Accuracy*
Clockwise: ±2%
Counter-Clockwise: ±3%
From 20% to 100% of capacity,
±1 least significant digit
Capacity
12 Nm
106.2 lb-in
8.85 lb-ft
122.4 Kg-cm
Resolution
0.01 Nm
0.1 lb-in
0.01 lb-ft
0.1 Kg-cm
Presets
1 Programmable setpoint with both audible
beep and Green/Red LED indicator
Operating Modes
Peak and Track
Drive
1/4 Inch - 6.35 mm Male Square
Power Supply
1x AAA Battery (included)
Battery Life
12 Hours of continuous operation
Auto Off
Automatic power off after 5 minutes of non-use
Operating Temp.
-10°C - 60°C
Storage Temp.
-20°C - 70°C
Length
8 inches / 20 mm
Warranty
1 Year
