ElectroMaax AQUAMAAX MODULAR SERIES, Installation, Operation & Maintanance Instructions

Page: 20 / 38

20
RO Pressure Vessel
The RO membrane assembly can be mounted in any location within reach of the control
panel flex lines supplied. The membrane assembly can be mounted in any orientation
when a control panel is supplied as this is a pressure feed system.
Control Panel Standard Option
The control panel can be mounted in any location within reach of the membrane assembly
due to the length of high pressure line that is needed. The typical standard length supplied
is
60 inches . All other lines to and from the remote panel are LLDPE plastic lines. When
mounting the panel, four holes are provided in each corner to affix the panel to a wall. The
flow meter must be in the
vertical position to read accurately the water flow produced by
the membrane.
Give consideration to the different water lines that will be going to and from the remote
panel and the RO Pressure Vessels which are the:
1. High pressure sea water inlet , coming from the high pressure pump.
2.
Brine seawater reject which will be routed off the boat from the panel.
3.
Fresh drinking water from the RO membrane to the remote panel.
4. Fresh drinking water line, coming from the 3-way product water selector valve on
the remote panel.
5.
The Product sample line, also coming from the 3-way product water selector valve
on the remote panel, but used to verify the water quality prior to routing the fresh
water to the ships water tanks.