TSE-P 01.01 EB
49/56
599 34 55-61
CONFIGURATION OF THE MAIN PCB
A standard main PCB is available as a spare part. This PCB contains only data relative to the wash cycle.
After replacing the main PCB, it is necessary to perform the configuration procedure in order to
operate the washing machine.
Configuration of the board consists of entering a 16-digit code which contains information which varies from
model to model (type of washing system, type of tub, type of appliance, spin speed, etc.).
To access the machine configuration procedure, first enter the diagnostics system, and then:
turn the programme selector one position
counter-clockwise; the display window shows
the code relative to the position of the
programme selector and, after two seconds,
the code relative to the first of the 16 digits of
the configuration code (i.e. position 0).
when one of the option buttons is pressed
(with the exception of the START/PAUSE
button), all the digits which make up the
configuration code are displayed in
sequence.
press the START/PAUSE button to
modify the configuration code (digit
by digit).
when all 16 digits have been entered,
check that the code is correct, then
memorize the code by pressing the
START/PAUSE button and one of the
option buttons at the same time;
these buttons should be held down
until the buzzer (if featured) sounds.
If the configuration is not entered correctly, the wash cycle will not start when the START button is pressed.
When configuration has been completed, perform the diagnostics routine in order to check that the
appliance functions correctly. In case of an error, the display window will show error code
E93
.
