16
Setup
3.3 Mechanical installation
If the machine is not to be mounted on a base the machine must be fastened to the floor.
The table shows the correct drilling points.
W565H-W5105H: Mark and drill two holes (
⌀
8 mm) about 40 mm deep in the positions shown.
W5130H-W5300H: Mark and drill two holes (
⌀
10 mm) about 50 mm deep in the positions shown.
⑧
C
A
D
G
F
E
B
H
FRONT
fig.5358
mm
A
B
C
D
E
F
G
H
W565H
495
460
110
130
375
170
40
100
W575H
495
460
110
130
375
170
40
100
W5105H
575
465
130
140
455
185
35
95
W5130H
635
490
135
175
515
195
60
110
W5180H
715
545
125
205
595
185
60
115
W5240H
790
615
115
180
670
175
60
115
W5300H
900
755
60
180
670
175
60
120
Place the machine over the two drilled holes. The holes are at the front of the machine.
Level the machine with the feet of the machine. Screw in the feet as much as possible before
starting to level the machine. This will make the machine stand steadier.
Insert the expansion bolts supplied into the holes drilled in the floor. Fit the washers and nuts
and tighten well.
It is of the upmost importance that the machine is placed in level, from side to side as well as front to rear. If
the machine is not properly levelled, it may result in out-of-balance without a real out of balance in the drum.
