g
8
When you have finished cleaning,
remove the accessories in the reverse
order of fitting.
0
Push the button on the end of the hose
(J) to pull out the suction hose.
3
Clean the accessories and store in a dry
place.
If the dirty water tank (25) is full, the
suction will be interrupted by a safety
device.
0
Open the housing lid (5) and empty the
dirty water tank (25) (T).
Wet Cleaning Carpets and
Upholstery
1
Check that the P. Tex cleaning agent
delivered with your appliance is suita-
ble for cleaning your rugs, fitted car-
pets or upholstery. Do this by carrying
out a test on a part of the item that
cannot be seen.
To obtain the best results you should
only use the original cleaning agent.
1
Only clean carpets and upholstery that
are suitable for wet cleaning. Delicate,
hand-woven or non-colour-fast car-
pets may not be wet cleaned.
3
Prior to wet cleaning carpets or uphol-
stery, thoroughly vacuum the entire
area to remove loose dirt.
If the carpet has previously been sham-
pooed there might be considerable
build-up of foam in the dirty water
container when P. Tex is used for the
first time. To avoid more foam, add half
a cup of vinegar to the dirty water
tank.
If foam comes out of the air vent,
switch off the appliance immediately
and empty the dirty water tank (T).
1
Check that there is no dust bag in
the appliance.
0
Turn the suction elbow (8) to the “Wet”
position (S).
0
Close the housing lid again (D).
0
Remove the fresh water tank (2).
0
Fill the fresh water tank with water
and cleaning solution in the quantities
stated on the cleaning agent bottle.
3
1 litre of cleaning solution is sufficient
to clean approx. 6.5 m
2
of carpet or
8 m
2
of hard floor.
Only use
hand-hot
water as higher
temperatures can damage the appli-
ance as well as the carpets and uphol-
stery.
0
Re-insert the filled fresh water tank
(2).
0
Connect the end of the hose to the
hose connector (6) (E).
0
Push the handle (21) into the suction
tube (20) and lock both pieces into
place.
0
Close the suction regulator on the han-
dle (22).
0
The accessories are attached to the end
of the suction tube (20):
• carpet spray extraction nozzle (13)
for wet cleaning rugs and carpets,
• upholstery spray extraction nozzle
(14) for wet cleaning upholstered
furnishings.
Only wet clean with the appliance
horizontal.
0
Press On/Off switch (4).
0
Press On/Off switch (9) for cleaning
pump (Y). This switches on the pump
and sends cleaning agent to the nozzle.
0
Using the electronic suction control (3)
you can set the required, continuously
variable, level of suction power (I).
0
To spray the cleaning agent, press the
spray dispensing button on the handle
(27).
3
To achieve the best possible cleaning
results proceed as follows:
1. When wet cleaning always pull the
carpet spray extraction nozzle (13)
towards yourself.
2. Finish cleaning as close as possible to
the door.
3
To avoid resoiling cleaned rugs or car-
pets, leave them to dry completely
before walking on them.
Summary of Contents for Praxio Z 6020
Page 4: ...e 4 ...
Page 5: ...e 5 21 27 28 29 15 ...
