Electrolux Praxio Z 6020, Instruction Book

Page: 9 / 10

g
9
1
After vacuuming liquids the suction
tube should be held up for a few sec-
onds with the appliance switched on.
This will suck the remaining liquid out
of the hose and suction tube.
0
When you have finished cleaning,
remove the accessories in the reverse
order of fitting.
0
To pull the suction hose (23) out press
the button on the end of the hose (J).
3
Clean the accessories and store in a dry
place.
If the dirty water tank (25) is full, the
suction will be interrupted by a safety
device.
0
Open the housing lid (5) and empty the
dirty water tank (25) (T).
Cleaning Hard Floors
0
Slide the hard floor adapter (15) onto
the carpet spray extraction nozzle (13)
(W).
This system enables you to clean and
dry hard floors in one process.
For cleaning hard floors see instruc-
tions for cleaning carpets.
3
For cleaning hard floors we recom-
mend the Electrolux cleaning concen-
trate P. Floor. This is available in the
shops.
Cleaning upholstery
Use the upholstery spray extraction
nozzle (14) to clean upholstered fur-
nishings or car seats.
The upholstery spray extraction nozzle
is pushed directly onto the spray dis-
pensing button (27). Pull the adapter
away from the stop valve and attach
the delivery hose to it by turning the
coupling.
3 Take care not to apply too much liquid
to upholstery as this could result in
lengthy drying times depending on the
substructure.
For method of cleaning see instruc-
tions for cleaning carpets.
Replacing the filter
Changing the motor protection
filter (M)
The motor protection filter is located
beneath the dirty water tank (25).
0
Open the housing lid (5) by pulling the
lid catch (7) and remove the dirty
water tank (25) (M).
0
Change the filter and then replace all
parts.
Changing the rear microfilter
(18)
0
Remove the fresh water tank (2) (N).
0
Pull out the filter lid (O).
0
Pull out the old microfilter and insert
the new microfilter (P).
0
Replace the filter lid and fresh water
tank.
Changing the side microfilter
(11)
0
Remove the exhaust guard (10) (Q).
0
Pull out the old microfilter and insert
the new microfilter (R).
0
Replace the exhaust guard (10).
3
The filter (Z 6035) is washable and re-
usable. Rinse the dirty filter only under
warm, running water and do not use
any cleaning agent.
What to do, if ...
• you press the spray dispensing button
on the handle (27) but no cleaning liq-
uid comes out:
– Have you pressed the cleaning pump
(9) On/Off switch?
– Is there any cleaning liquid in the
fresh water tank?
Top up the cleaning liquid if necessary.
– Is the spray nozzle blocked?
Place the nozzle for a short while in
lukewarm water and then blow
through it hard.
– Is the tank connection opening
blocked?
Remove the fresh water tank and
thoroughly vacuum the tank con-