Electrolux Praxio Z 6020, Instruction Book

Page: 7 / 10

g
7
• Repairs to electric appliances are
only to be carried out by approved
specialists. Improperly effected
repairs may result in considerable
risk to the user.
• In the case of a malfunction, therefore,
please contact your dealer or Elec-
trolux customer service directly.
• The manufacturer accepts no responsi-
bility for possible damages caused by
non-regulation use or wrong operation
of the appliance.
Dry vacuuming
1
Important: Once the appliance has
been used for wet vacuuming, it must
be allowed to dry completely; if neces-
sary the hose and tubes must also be
completely dried before use.
0
Open the appliance by pulling the lid
catch (7) (A).
0
Insert the dust bag (24) in the guide
and push as far as it will go (B).
0
Turn the suction elbow (8) to the
“Dry” position (C).
0
Close the housing lid again (D).
0
Connect the end of the hose to the
hose connector (6) (E).
0
The accessories are pushed on to the
end of the suction tube (20a/b) (F).
• Floor nozzle (19)
• Crevice nozzle (17): eg. for vacuum-
ing corners and crevices.
• Upholstery nozzle (16).
0
Pull out the power supply cable (G) and
insert the plug into a socket.
0
Press the ON/OFF switch (4) (H).
0
Using the electronic suction control (3)
(Z 6035 only) you can set the required,
continuously variable, level of suction
power. (I). The suction power can also
be regulated at the handle (F/22).
1 Hot ashes, glowing cigarette ends,
inflammable or corrosive materials and
fine dust must not be vacuumed.
When using deodorisers in the dust
bag, please observe the manufacturer's
instructions exactly.
When you have finished cleaning,
remove the accessories in the reverse
order of fitting.
To pull the suction hose (23) out press
the button on the end of the hose (J).
Dust bag full indicator
The indicator on the housing lid (26)
will show red when the dust bag (24) is
full.
1
Always change the dust bag after
cleaning floors that have previously
been treated with powder cleaners, as
residues will damage the appliance
over time.
The dust bag has a flap that retains the
vacuumed dirt (L).
Wet vacuuming
0
Open the appliance by pulling the lid
catch (7) (A).
1 Check that there is no dust bag in the
appliance.
0
Turn the suction elbow (8) to the
“Wet” position (S).
Only wet vacuum when the appli-
ance is horizontal.
0
Close the housing lid again (D).
0
Connect the end of the hose to the
hose connector (6) (E).
0
Push the handle (21) into the suction
tube (20) and lock both pieces into
place.
0
Close the suction regulator (22) on the
handle.
0
Press the ON/OFF switch (4) (H).
0
Using the electronic suction control (3)
you can set the required, continuously
variable, level of suction power (I).
1 After vacuuming liquids the suction
tube should be held up for a few sec-
onds with the appliance switched on.
This will suck the remaining liquid out
of the hose and suction tube.