36
Oven door locks when the oven is programmed
for clean but the oven does not heat:
1.
If the oven operates normally in bake, replace the
control.
Lock motor runs continuously:
1.
With the door in the unlock position, remove power
from the range. Go to the back of the control and
disconnect the 15 pin plug from the control. With an
Ohmmeter measure the resistance between pins 9
and 10 of the 15 pin plug (not on the EOC). If the
meter reads zero the lock switch or the wiring to the
lock switch is defective. If the meter reads infinity
go to step 2.
2.
Depress the arm of the lock switch, and measure
the resistance between pins 9 and 10 of the 15 pin
plug. If the meter reads infinity the lock switch or
the wiring to the lock switch is defective. If the meter
reads zero the control is defective.
Door latch is partly closed with door open, cannot
close door:
1.
Program the oven for self-clean, and hold in on the
door switch for 30 seconds. Touch cancel and
hold door switch in for 30 seconds. The lock
motor should lock and unlock the door.
Summary of Contents for NEXT GEN
