Electrolux LU7, Owner'S Manual, Page: 8 / 16

10
Fig. 14
• Connect the rinse-aid dispenser between termi-
nals 8 and 9. These connection points are live dur-
ing filling of the tank and at the end of the rinse
cycle for a set time (see “setting the dispensers”
paragraph).
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air.
Simultaneously press the buttons, as shown in the fig-
ures below. If necessary, repeat this operation several
times.
In the appliances with pressure boiler, the diaphragm
dispenser pump may be manually activated by press-
ing screw “D” (Fig. 12).
B5 SETTING THE DISPENSERS
1) Peristaltic dispensers
All operations should be carried out with the appliance
switched on, the door open and no cycle selected.
SEQUENTIAL START
Press the indicated buttons simultaneously for 5 sec-
onds:
Display of programming mode:
Initial amount of detergent:
Setting the activation time:
Initial amount of rinse-aid:
Setting the activation time:
Amount of detergent during the cycle:
Setting the activation time:
Amount of rinse-aid during the cycle:
Setting the activation time:
Exit from programming mode:
Notes for external dispensers:
- if

the detergent dispenser only oper-
ates during wash pump operation; terminals 7-9 of
the main terminal board are powered at the same
time.
DETERGENT DISPENSER DISPENSER RINSE-AID
LEGEND
Increase
Decrease
Confirm or select next parameter
1
2 3 1 2 3
1
1 2 3 GEn
dln
45
1 2 3 45
rln
1 2 3 10
dEt
1 2 3 8
rAl
1 2 3 4
GEn