14
Steel
Clamp
Stainless
Steel
water Line
Water Valve
Bracket
Valve Inlet
Water Valve
6 ft. Stainless Steel water line
from household water supply
Plastic Water Tubing
to Ice Maker
Fill Tube
Figure 2
Figure 1
Plastic Water Tubing
to Ice Maker
Fill Tube
Steel
Clamp
Brass
Compression
Nut
Ferrule
(Sleeve)
Copper
water line
Water Valve
Bracket
Valve Inlet
Water Valve
Copper water line
from household
water supply
(Include enough tubing in loop to
allow moving refrigerator out
for cleaning)
NOTE
Check with your local building authority
for recommendations on water lines and
associated materials prior to installing
your new refrigerator. Depending
on your local/state building codes,
Electrolux recommends for homes
with existing valves its
Smart Choice
®
water line kit 5305513409 (with a
6-ft. Stainless Steel Water Line) and
for homes without an existing valve,
Electrolux recommends its
Smart
Choice
®
water line kit 5305510264
(with a 20-ft. copper water line with
self-tapping saddle valve). Please refer
to
www.electroluxappliances.com
for
more information.
Connecting Water Supply
To Connect Water Supply Line
To Ice Maker Inlet Valve:
1. Disconnect freezer from electric
power source.
2. Place end of water supply line into
sink or bucket. Turn ON water supply
and flush supply line until water
is clear. Turn OFF water supply at
shutoff valve.
3. Remove plastic cap from water valve
inlet and discard cap.
4. If you use copper tubing
- Slide
brass compression nut, then ferrule
(sleeve) onto water supply line. Push
water supply line into water valve inlet
as far as it will go (¼” / 6.4 mm). Slide
ferrule (sleeve) into valve inlet and
finger tighten compression nut onto
valve. Tighten another half turn with
a wrench; DO NOT overtighten. See
Figure 1.
If you use stainless steel tubing
- The nut and ferrule are already
assembled on the tubing. Slide
compression nut onto valve inlet and
finger tighten compression nut onto
valve. Tighten another half turn with
a wrench; DO NOT overtighten. See
Figure 2.
5. With steel clamp and screw, secure
water supply line (copper tubing only)
to rear panel of freezer as shown.
6. Coil excess water supply line (copper
tubing only), about 2½ turns, behind
freezer as shown and arrange coils
so they do not vibrate or wear
against any other surface.
7. Turn ON water supply at shutoff valve
and tighten any connections that leak.
8. Reconnect freezer to electrical
power source.
9. To turn ice maker on, lower wire
signal arm (side mounted) or set the
ice maker’s On/Off power switch to
the “I” position (rear mounted).
Summary of Contents for ICON E32AF85PQS
Page 24: ......
