7
Installing Door Handle & Leveling
Door Handle
Mounting Instructions
1. Remove handle from carton and any
other protective packaging.
2. Position handle end caps over upper
and lower preinstalled shoulder bolts
(A) that are fastened into door.
3. While holding handle firmly against
door, fasten upper and lower Allen
set screws (B) with supplied Allen
wrench until there is no gap between
handle and door.
NOTE
All set screws should be tightened so the
screw is below the surface of the handle.
The handles should be drawn tight to
freezer and refrigerator doors with no gaps.
Opening the opposite door while tightening
the Allen screw makes installation easier.
The door handle may loosen over time or if
it was installed improperly. If this happens,
tighten the set screws on the handles.
Toe Grille Removal
To remove the toe grille, use a Phillips
screwdriver and remove the two screws
holding the toe grille to the cabinet. Then
pull the toe grille away from the unit.
Leveling
• The freezer must have all bottom
corners resting firmly on a solid floor.
• The floor must be strong enough to
support a fully loaded freezer.
• It is
VERY IMPORTANT
for your
freezer to be level in order to function
properly. If the freezer is not leveled
during installation, the door may be
misaligned and not close or seal
properly, causing cooling, frost or
moisture problems.
Remove
Screws
Toe Grille
Summary of Contents for ICON E32AF85PQS
Page 24: ......
