45
The outer liner of the freezer has a 3/16” flange and the
inner liner has (2) grooves in it.
The trim has a channel with a locking tab that snaps
down over the inner liner and a flange with a locking tab
that snaps under the flange of the outside liner.
The end caps are formed to allow the trim to slide into
them.
Removing the Trim:
1.
Lift the freezer lid and starting at the inside center,
lift up and out on the trim to disengage it from the
inside liner. Then pull up and out on the trim to
disengage it from the foam, and the flange of the
outer freezer liner.
2.
Once the trim has been disengaged from the liners
and the foam, bow the center of the trim up to
disengage from the end cap.
To Remove the End Caps:
1.
Lift the lid and remove one the the pieces of trim
connect to the end cap.
2.
Lift up on the front edge of the end cap, that is in line
with the remaining piece of trim, and slide it off.
