Electrolux FPUH17D7KF All Freezer Professional Series, Servicing

Page: 18 / 84

Section 2 Installation Information
2-10
Installing Trim & Grill Assembly Into Cabinetry
1. First, place protective covering where side trim will
contact the floor near rough opening. Then, stand
up the grill and frame assembly and center in rough
opening. You may need to use several pieces of
tape at the top corners and top center to temporarily
hold the assembly in place. (See Figure 2-14).
2. Making sure the frame is flush up against the front
surface of cabinetry, carefully run one mounting
screw (M) through the center hole of the top trim
(A) and into the cabinetry. DO NOT tighten at this
time.
3. Level the top of the trim frame using a carpenter’s
level. (See Figure 2-15).
Figure 2-14.
Figure 2-15.
4. Shim as necessary (shims are not included). (See
Figures 2-16 and 2-17). Next, secure both ends of
top trim (A) to cabinetry using two 3/4” mounting
screw (M) through the holes at each end. Make sure
all screws are snug across the top.
5. Using a carpenter’s level, check that each side
is vertical. Shim as necessary (shims are not
included). Next, secure top and bottom of each side
trim to cabinetry using two 3/4” mounting screws
(M). (See Figure 2-18).
Figure 2-16.
Figure 2-17.
Some cabinet substrates may require pre-drilling holes
using a 1/8” diameter drill bit.
NOTE
Figure 2-18.