9
FMV156EMC
result in severe, possibly fatal, electric shock.
(Example)
High Voltage capacitor, Power transformer, Magnetron, High Voltage Rectifier Assembly, High Voltage Harness
etc..
WARNING:
Avoid possible exposure to microwave energy. Please follow the instructions below before operat-
ing the oven.
WARNING AGAINST HIGH VOLTAGE:
Microwave ovens contain circuitry capable of producing very high voltage and current, contact with following parts may
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
To prevent an electric shock, take the following pre-
cautions.
1. Before wiring,
1) Disconnect the power supply cord.
) open the door block it open.
3) Discharge the high voltage capacitor and wait for 60
seconds.
. Don’t let the wire leads touch to the followiong parts;
1) High voltage parts:
Magnetron, High voltage transformer, High voltage
capacitor and High voltage rectifier assembly.
) Hot parts:
oven lamp, Magnetron, High voltage transformer and
oven cavity.
WARNING FOR WIRING
1. Disconnect the power supply cord.
. Make sure that a definite” click” can be heard when
the microwave oven door is unlatched. (Hold the door
in a closed position with one hand, then push the door
open button with the other, this causes the latch leads
to rise, it is then possible to hear a “click’ as the door
switches operate.)
3. Visually check the door and cavity face plate for damage
(dents, cracks, signs of arcing etc.).
carry out any remedial work that is necessary before
operating the oven.
Do not operate the oven if any of the following conditions
exist;
1. Door does not close firmly.
. Door hinge, support or latch hook is damaged.
3. the door gasket or seal is damaged.
4. the door is bent or warped.
5. there are defective parts in the door interlock
system.
6. there are defective parts in the microwave generating
and transmission assembly.
7. there is visible damage to the oven.
Do not operate the oven:
1. Without the RF gasket (Magnetron).
. If the wave guide or oven cavity are not intact.
3. If the door is not closed.
4. If the outer case (cabinet) is not fitted.
3) Sharp edge:
Bottom plate, oven cavity, Waveguide flange,
chassis support and other metallic plate.
4) Movable parts (to prevent a fault)
Fan blade, Fan motor, Switch, open lever, open
button.
3. Do not catch the wire leads in the outer case cabinet.
4. Insert the positive lock connector until its pin is locked
and make sure that the wire leads do not come off
even if the wire leads are pulled.
5. to prevent an error function, connect the wire leads
correctly, referring to the Pictorial Diagram.
Please refer to ‘oVEN PARtS, cABINEt PARtS, coNtRol PANAl PARtS, DooR PARtS’, when carrying out any of
the following removal procedures:
THE FOLLOWING ADJUSTMENTS OR COMPONENT REPLACEMENT CAN BE PERFORMED
WITHOUT REMOVING THE OVEN FROM THE WALL
1. Hood lamps, sockets, grease filter and charcoal filter.
. Base cover and hood lamp glass assembly.
3. turntable motor.
4. Hood exhaust louver.
5. control panel assembly or components.
HOOD EXHAUST LOUVER REMOVAL
1. Disconnect the power supply cord.
. open the door and block it open.
3. to discharge the high voltage capacitor, wait for 60
seconds.
4. Remove the three (3) screws holding the hood exhaust
louver to the oven cavity front face plate.
Summary of Contents for FMV156EMC
Page 46: ...46 FMV156EMC NOTES ...
Page 47: ...47 FMV156EMC NOTES ...
