Service
Manual
9406
Setting the water level
This is the procedure for determing how many "units"
are needed to reach a given water level in the drum
(so that this value can be entered in the wash
program):
•
The key on the control panel of the machine must
be in the WASH position. Set the service switch to
posotion 4, Service program.
•
Press O, 1 and START. This activates the cold
water valve and the level detector. (To activate the
hot water valve, press 0, 2, and START). The
following text appears on the display:
LEVEL 1, 2 and 3 show the manufacturer's
recommended figures for level 1 (Empty), level 2
(Low) and level 3 (High) for this model. LEVEL 1
(Empty) is used by the microprocessor as a limit value
for opening the door, switching on heating elements (if
any) and starting the spin. LEVEL 1 cannot be
reprogrammed and is shown as a reference only.
The reading at LEVEL on the bottom line of the
display increases as the water level rises in the drum.
When the desired level is reached, press START
again to shut the water walve. The water level can
now be read off on the bottom line.
The TEMP. indicator shows the inlet temperature of
the water. On the basis of this figure the programmer
can determine exactly the inlet temperature of the
water when choosing COLD WATER or HOT
WATER. If the model in question does not have built-
in heating elements or steam heating, the highest
possible water temperature is determined by the inlet
temperature of the hot water (which may be very much
lower than the outlet temperature from a water heater
unit because of losses in pipes).
SERVICE PROGRAM CHOOSE FUNCTION 001
COLD WATER
**ON** LEVEL: 1>XXX 2>XXX 3>XXX
LEVEL XXX TEMP. XXX
°
C
26. Level Detection
26
2
