Service
Manual
9406
The following steps should be taken to maintain
optimum safety and performance of the machine and
to prevent breakdowns.
The timing should be adapted to the usage of the
machine.
Daily
•
Chek door and safety locking device.
– Close door, start machine and check door
cannot be opened.
– Stop machine and check that door cannot be
opened until 20-30 seconds have elapsed after
programme ends.
– Open door and raise hadle to closed position.
Check machine cannot be started. If it can,
there is a fault on the hinge side switch which
must be dealt with immediately.
– Check that door does not leak.
Clean door seal.
•
Check that drain valve and inlet valve does not
leak wash.
– Leak can be detected by the machine filling with
water during washing or water from the drain
valve.
Every three months
•
Switch off main switch.
•
Remove rear and front protective plates and top
panel. Do not forget screws for detergent
compartment. Check in the detergent compartment
that there is no leak between the compartment and
the top panel.
•
Check that all inner pipe connections are not
leaking.
•
Check door does not leak.
•
Check V-belts; tighten or replace as required, refer
to section 30. Motor – drive unit.
•
Check spring suspension and shock absorbers.
•
Check heater elements if heating time unusually
long. See section 40. Heating elements.
•
If water is very hard, check the elements for "lime
scale". Where necessary, treat with descaling
agent. Use descaling agent in accordance with
manufacturer's instructions.
•
Check the spin cutout with the machine unloaded,
the centre of the bracket should be about 5 cm
above the pin.
See section 28. Spin cutout.
11. Periodic maintenance
11
1
