7. Put the filter (B) to its initial position. Make
sure that it assembles correctly under the
two guides (C).
8. Put the filter (A) into position in filter (B)
and turn it clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove remaining parts of soil with a cocktail
stick.
To clean the external surfaces
Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only
use neutral detergents. Do not use abrasive products, scouring pads or solvents (e.g. ace
-
tone).
What to do if…
The appliance does not start or stops during operation.
First try to find a solution to the problem (refer to the chart). If not, contact the service
centre.
Malfunction
Fault code
Possible cause
Possible solution
The appliance does not
fill with water.
• An audible signal
operates.
• The display shows
the message OPEN
THE TAP .
The water tap is closed. Open the water tap.
The water pressure is
too low.
Contact your local wa
-
ter authority.
The water tap is
blocked or is furred
with limescale.
Clean the water tap.
The filter in the water
inlet hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the
connection is correct.
C
18
What to do if…
