Electrolux EXD16DN4W, User Manual

Page: 9 / 218

9 ENGLISH
NOTE:
• The Dryer mode must be operated in a
close room, do not open the door and
window.
• To make the best effective
dehumidification, please first dehydrate
the wet clothes.
• Make sure to direct airflow at the wet
clothes shown as picture below.
• For thick and heavy wet clothes may not
get the best effective dehumidification.
CAUTION!
• Do not cover the air outlet of the
unit with clothes. It may cause
excessive heat, fire or failure
of unit.
• Do not place the wet clothes on
the top of the unit and do not
make the water drop into the
unit. It may cause electric shock,
creepage or failure of unit.
4.7 How to Use Timer Function
The TIMER function enables you to
either Delay Start or Delay Stop the unit
in the choice from 0.5 hour to 24 hours.
When the unit is on, press the Timer
button, the Timer indicator light
illuminates. It indicates the Auto Stop
program is initiated. When the unit is
off, press the Timer button, the timer
indication light illuminates. It indicates the
Auto Start is initiated.
Press or hold the or pad to change
the Auto time by 0.5 hour increments, up
to 10 hours, then at 1 hour increments up
to 24 hours. The control will count down
the time remaining until start.
The selected time will register in
5 seconds and the system will
automatically revert back to display
the previous humidity setting.
Turning the unit ON or OFF at any time
or adjusting the timer setting to 0.0 will
cancel the Auto Start/Stop function.
When LED display window displays the
code of P2, the Auto Start/Stop function
will also be cancelled.
NOTE:
• Before entering TIMER setting, make
sure power is being supplied to the unit.
• Before entering TIMER setting, make
sure pressing HUMIDITY or button
sets one desired room humidity first.
4.8 Fault Codes
AS- Humidity sensor error--Unplug the
unit and plug it back in. If error repeats,
call for service.
ES- Temperature sensor error-- Unplug
the unit and plug it back in. If error
repeats, call for service.
P2-
Bucket is full or bucket is not in right
position-- Empty the bucket and replace
it in the right position.
4.9 Removing collected water
There are two ways to remove collected
water.
Use the bucket
When the unit is off, if the bucket is full,
the unit will beep 8 times and the Full
indicator light will flash, the digital display
shows P2.
When the unit is on, if the bucket is full,
the compressor turns off and the fan
turns off after 30 seconds for drying the
water of the condenser, then the unit will
beep 8 times and the Full indicator light
will flash, the digital display shows P2.
Follow the step below to remove the
collected water from the bucket:
1. Grip the left and right handles securely,
then pull out the bucket a little.
2. Hold both sides of the bucket with even
strength, and pull it out from the unit.