Electrolux EXD16DN4W, User Manual

Page: 12 / 218

12 www.electrolux.com
Occurrence Solution
Dehumidifier does not operate Wall plug disconnected. Push plug firmly
into wall outlet.
House fuse blown or circuit breaker
tripped. Replace fuse with time delay
type or reset circuit breaker.
The dryness level you selected has been
reached. Dehumidifier automatically shuts
off when selected amount of moisture
has been removed from the air. If you
want to remove more moisture, Select
CONTINUOUS by using the humidity
button or knob. After the dehumidifier
starts, reset the control to the desired
setting.
Bucket not installed properly. See
“Removing Collected Water”.
Water in the bucket has reached its
preset level. Dehumidifier automatically
turns off when this occurs. Empty bucket
and return bucket to position.
Dehumidifier is not turned on. Turn unit on.
BUCKET FULL light is on. Remove
bucket, empty water and re-install
correctly.
Dehumidifier runs too much Windows or doors near dehumidifier are
open to outdoors. Close all windows or
doors to outside.
Area to be dehumidified is too large.
Check with your dealer to see if capacity
is adequate.
Air movement through dehumidifier is
blocked. Grill may be dirty. Use brush
attachment of vacuum cleaner to
clean grill. See “Care and Cleaning”.
Dehumidifier must be placed in a space
that does not restrict air flowing into the
rear coil or out of the front grill.
Dehumidifier has been installed or
restarted recently. The higher the
moisture in the room, the longer the
dehumidifier will operate.
Dehumidifier is in the CONTINUOUS
mode and will remain on in this mode, use
the humidity button or knob to set a RH%
higher level.