Electrolux EXD16DN4W, User Manual

Page: 7 / 218

7 ENGLISH
authorized Electrolux servicer for
repairs.
• Do not insert or place fingers or
objects into the air discharge area or
front grille of the unit.
• Do not start or stop the dehumidifier by
unplugging the power cord or turning
off the power at the electrical box.
• Do not cut or damage the power cord.
• If the power cord is damaged, it should
only be replaced by an authorized
Electrolux servicer.
• In the event of a malfunction (sparks,
burning smell, etc.), immediately stop
the operation, disconnect the power
cord, and call an authorized Electrolux
servicer.
• Do not operate the dehumidifier with
wet hands.
• Do not pull on the power cord.
• Do not drink any water from the
dehumidifier.
CAUTION!
Avoid Injury or damage to the unit
or other property
• Do not direct airflow at fireplaces or
other heat related sources as this
could cause flare ups.
• Do not climb on or place objects on
the unit.
• Do not hang objects off the unit.
• Do not place containers with liquids
on the unit.
• Turn off the dehumidifier at the power
source when it will not be used for an
extended period of time.
• Operate the unit with air filter in place.
• Do not block or cover the intake grille,
discharge area and outlet ports.
• Ensure that any electrical/electronic
equipment is one yard away from the
unit.
• Do not use or store flammable gases
near the unit.
3.
BEFORE FIRST USE
3.1 Selecting a Location
Important
1. Dehumidifier must be operated in an
enclosed area to be most effective.
Close all doors, windows, and other
outside openings to the room. The
effectiveness of the dehumidifier
depends on the rate at which new
moisture-laden air enters the room.
2. Place dehumidifier in a location that
does not restrict airflow through the
front of the unit.
3. A dehumidifier operating in a
basement will have little or no effect
in drying an adjacent enclosed storage
area, such as a closet, unless there
is adequate circulation of air in and
out of the area. lt may be necessary
to install a second dehumidifier in the
enclosed area for satisfactory drying.
4.
The dehumidifier must be installed on
a level floor that will support it with a
full bucket of water.
5.
There should be a minimum of
12 inches clearance around the
dehumidifier.
3.2 How It Works
When the unit is started, the fan begins
to pull moisture-laden air across the
dehumidifying coils. The coils condense
or draw moisture from the air, and air
flows into the room as dry, warm air.
Moisture removed from air is collected in
a bucket on the front of the dehumidifier.
The unit is designed to operate between
5°C (41°F) and 35°C (96°F). The unit
will not work properly if the temperature
is out of this temperature range, or
the performance of the unit will fall
greatly. The “Compressor” circuit has an
automatic 3 minute time delayed start if
the unit is turned off and on quickly. This
prevents overheating of the compressor
and possible circuit breaker tripping.
Make sure the tank is fitted correctly
otherwise unit will not turn on.