Electrolux EWW 1291, Instruction Booklet

Page: 13 / 29

ENGLISH
10 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the machine. The light above the button will stop
flashing and remain lit.
If you have selected a delay start by means of
button 12, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progressis interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important!
You must set the machine to PAUSE before you
make any change in the programme in progress.
11 SKIP/RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the machine on, the blinking zero will reappear and
the audible warning signals relevant to the end of the
previous cycle will be given.
You can also press the SKIP/RESET button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP/RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go
out).
START/PAUSE
Example:
In this case, both the
drain and the spin (at the
speed provided for the
selected type of fabric)
will be performed.
This button allows you also to select special
programmes
, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress SKIP/RESET once or repeatidly to cancel
the previously performed programme;
- select the type of fabric by means of FABRICS
button;
- select the special programme:
• RINSES
Depress SKIP/RESET once, the pilot light WASH
goes out.
• SPIN
Depress SKIP/RESET twice, the pilot lights WASH
and RINSES go out.
• DRAIN
Depress SKIP/RESET three times, the pilot lights
WASH
, RINSES and SPIN go out, and only the
pilot light DRAIN will light on .
Example:
In this case the machine
will perform the rinses
followed by the spin.
13
132984360.qxd 06/09/2006 14.47 Pagina 13