SOI/DT 2005-07 dmm
33/59
599 37 22-15
Notes
:
AF
indicates if antifoam function is active
FUCS
antiunbalance function before spin phase
x
variable
duration
•
In the diagrams the speed is indicated as rotations per minute and the time in seconds
6.16 Control of water level in tub
The water fill is carried out in two phases:
•
level fill:
is controlled by the closure of 1
st
level pressure switch in the FULL position
•
time fill:
the duration is calculated by the electronic board to fill the correct quantity.
The different levels are determined by the model configuration and depend on the type of tub used.
Notes
:
P1
time needed to 1
st
level water fill
(*)
time water fills are variable and are calculated by the electronic board on the basis of the
delivery rate (see specific table)
T
time needed to heat the water to the set temperature
”
seconds
‘
minutes
VAE
time needed to drain the water until the anti-boiling (safety heater) pressure switch goes to
"EMPTY"
Movement
: this column shows the drum movements at low speed and during spin. (See paragraph “drum
movements”)
The times of drain phases with spin cycle are indicative and do not take into consideration the
intervention of the antiunbalancing and antifoam devices.
