Electrolux EWF 1081, User Information

Page: 28 / 48

28
The washing machine vibrates
during operation or it is on an
uneven surface.
The transport safeguard has not been
removed.
Remove transport safeguard as indi-
cated in the instructions for installa-
tion and connection.
The height-adjustable screw feet are
not correctly set. Adjust in accordance with the installa-
tion and connection instructions.
There is not much washing in the
drum (e.g. only one dressing gown). This does not impair the operation of
the machine.
The water could not be completely
pumped off before spinning because
the drainage hose is bent
or
the solution pump is blocked. Check the laying of the drainage hose
and eliminate the bend if necessary,
or clean the solution pump and, if
required, remove foreign bodies from
the pump housing.
The washing solution of the
main wash froths up a lot. Too much detergent was probably
used.
Meter the detergent exactly in accord-
ance with the manufacturer's informa-
tion.
Water runs out under the
washing machine.
The screw connection on the intake
hose is leaky. Tighten the intake hose screw con-
nection.
The drainage hose is leaky.
Check the drainage hose and replace
it if necessary.
The washing solution pump cover is
not correctly closed.
Close cover correctly.
Washing stuck in the filling door.
Stop the program, remove washing
from the filling door, start a new pro-
gram.
The emergency drain hose is not
properly shut off or it is not water-
tight.
Shut the emergency drain hose off
properly (see section "Performing an
Emergency Drain"). Call your after-
sales service if the emergency drain
hose is not water-tight.
Fault code EF0 appears.
The Aqua Control anti-flood system
has been activated.
Turn off the tap, then remove the plug
from the mains and inform Customer
Service.
The drain pump for the wash-
ing machine runs constantly -
even when the appliance is
switched off.
Conditioner not added, com-
partment
æ
for care agent full
of water.
Softener insert in the compartment for
care agent not correctly attached or is
blocked.
Clean the detergent drawer and firmly
attach the softener insert.
Washing heavily creased. Too mush washing probably put in.
Pay attention to the maximum filling
quantity (see Program Tables). For
easy-care textiles, select the program
EASY IRON (Leichtbügeln, Fâcile à
Repasser).
The washing has not been
spun as dry as usual.
The washing was not able to be dis-
tributed evenly in the drum prior to
spinning. Always load the drum as full as possi-
ble with a combination of large and
small items.
Problem Possible Cause Remedy