Electrolux EWF 1081, User Information

Page: 22 / 48

22
Washing Cycle Ended/Remove Washing
After a washing program has ended, END (Ende, Fin)
lights up on the program sequence display.
If you selected RINSE HOLD (Spülstopp, Arrêt cuve
pleine), the indicator next to the button START/
PAUSE (Marche/Pause) flashes.
1. After a rinse hold, it is first necessary to pump off
the water:
– Press either the button START/PAUSE
(Marche/Pause)
(water is pumped off and the washing is spun
according to the program which has just run;
after pressing the button START/PAUSE
(Marche/Pause) again, the spin speed can also
still be changed during spinning),
or
– first turn the programme selector to OFF (Aus,
Arrêt)
.
Then turn the program selector to PUMP OUT
(Pumpen, Vidange) and press the button
START/PAUSE (Marche/Pause)
(water is pumped off without spinning)
or
– first turn the programme selector to OFF (Aus,
Arrêt)
.
Then turn the program selector to SPIN (Sch-
leudern, Essorage) or SHORT SPIN (Schon-
schleudern, Essorage Délicat) and press the
button START/ PAUSE (Marche/Pause)
(water is pumped off and the washing is spun
or gently spun).
After the end of this program step, the indicator END
(Ende, Fin) lights up.
2. Open the filling door.
As soon as the indicator DOOR (Tür, Porte) lights
up green, the filling door can be opened.
3. Remove the washing.
4. Turn the program selector to OFF (Aus, Arrêt).
5. After washing, pull out the washing detergent
drawer slightly so that it can dry out. Only lean the
door against the washing machine so that the lat-
ter can air out.
3
If the display OVER DOSING (Überdosiert,
Surdosage) lights up, too much washing
detergent was used in the washing program
just ended. During the next wash, pay atten-
tion to the dosing information of the washing
detergent manufacturer and pay attention to
the filling quantity!
Attention! If the washing machine is not used for a
long time: Close the water tap and disconnect the
washing machine from the electricity mains. (The
Aqua Control water protection does not function if
the power supply is interrupted).