The end of the drain hose must always be ventilated
, i.e. the inner diameter of the drain pipe (min. 38 mm -
min. 1.5") must be larger than the external diameter of the
drain hose.
5. Without the plastic hose guide, to a sink spigot- Put the
drain hose in the spigot and tighten it with a clamp. Refer
to the illustration.
Make sure that the drain hose makes a loop to prevent
particles going into the appliance from the sink.
Position the hose directly to a drain pipe and tighten it with
a clamp.
6. Position the hose directly to a built-in drain pipe in the
room wall and tighten it with a clamp.
5.3 Electrical connection
Connect the mains plug to the mains socket only at the end
of the installation.
Make sure that the parameters on the rating plate are
compatible with the electrical ratings of the mains power
supply.
Necessary data are available in the chapter „Technical
data“.
Be sure that your domestic power circuit can withstand the
maximum power consumption; please also consider other
appliances that might be connected to the same circuit.
Always use a correctly installed shockproof socket.
Make sure that there is access to the mains plug after the
installation.
For any electrical installation works, please contact our
qualified client service.
Manufacturer is not liable for any damage or injury that is
caused by negligence of before mentioned safety
requirements.
6. ACCESSORIES
6.1 Fixing plate kit
(4055171146)
If you install the appliance on a plinth, secure the appliance
in the fixing plates.
6.2 Stacking kit
The tumble dryer can be stacked on the top of the
washing machine only by using the correct stacking kit.
