5.2 Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent vibration, noise
and movement of the appliance when it operates.
1. Install the appliance on a flat hard floor. The appliance
must be levelled and stable. Make sure that the appliance
does not touch the wall or other units and there is air
circulation below the appliance.
2. Loosen or tighten the feet to adjust the level. All feet
must rest firmly on the floor.
WARNING!
Do not put cardboard, wood or equivalent materials
below the appliance feet to adjust the level.
The inlet hose
CAUTION!
Make sure there is no damage to hoses and there are no
leaks from the couplings.
Do not use an extension hose if the inlet hose is too short.
Contact the service centre for a replacement inlet hose.
1. Connect the water inlet hose to the back of the
appliance.
2. Position it toward left or right depending on the positon
of the water tap.
Make sure that the inlet hose is not in vertical position.
3. If necessary, loosen the ring nut to set it in the correct
position.
4. Connect the water inlet hose to the cold water tap with
3/4'' thread.
Water drainage
The drain hose should stay at a height of no less than 60 cm
and not more than 100 cm.
You can extend the drain hose to maximum 400 cm.
Contact the service centre for the other drain hose and the
extension.
It is possible to connect the drain hose in different ways:
1. Make a U shape with the drain hose and put it around
the plastic hose guide.
2. On the edge of a sink - Fasten the guide to the water tap
or to the wall.
Make sure that the plastic guide cannot move when
the appliance drains and the drain hose end is not
immersed in the water. There may be a return of dirty
water into the appliance.
3. If the end of the drain hose looks like this (see the
picture), you can push it directly into the stand pipe.
4. To a stand pipe with vent-hole - Insert the drain hose
directly into a drain pipe. Refer to the illustration.
