7
ENGLISH
2.4
Installation site
• Do not install the unit in areas with:
– strong heat sources;
–
vapours or flammable gases;
– contamination with oil particles;
– high frequency electromagnetic
equipment (e.g. welding equipment
or medical devices);
– high salinity (e.g. close to coastal
areas);
– sulphuric gas (e.g hot water springs);
– poor air quality.
Indoor unit
• Maintain the minimum installation
distances specified in this document.
Do not block the air inlet or the air
outlet.
• Do not use the unit in places with
extremely high humidity.
• Install the indoor unit out of reach of
children.
• The wall must be strong enough to
support the weight and vibration of the
unit.
• Install the indoor unit at least 230 cm
above the floor surface.
•
Leave sufficient space for cleaning and
maintenance.
•
The air filter should remain accessible.
• Leave at least 1 m distance between
the unit and other electrical appliances.
• Install the indoor unit in a place where
the condensate water can be easily
drained.
• Install at a location protected from
direct sunlight.
Outdoor unit
• Maintain the minimum installation
distances specified in this document.
• Do not block the air inlet or the air
outlet.
• Install the outdoor unit out of reach of
children.
• Install the outdoor unit where there is
sufficient ventilation.
• Install the outdoor unit where produced
noise and airflow will not disturb
neighbors or animals.
• Install the outdoor unit in a dry place.
• Install the outdoor unit in a place not
exposed to direct sunlight or strong
wind.
• Install the outdoor unit in a place can
support the weight and vibration of the
unit.
•
Leave sufficient space for cleaning and
maintenance.
Safety precautions for electrical appliances
• Use a dedicated mains circuit.
• The unit must be properly grounded.
• Install a Residual-current device (RCD)
to protect against personal injury in
case of leakage currents.
• The installation must comply with local
electrical safety regulations and with
other relevant local regulations.
• The unit must be installed in
accordance with national wiring
regulations.
• Do not subject the mains cable to force.
• The distance between the unit and heat
sources is at least 1.5 m.
NOTE
• Make sure that the live wire, the neutral
wire and the ground wire in the mains
socket are properly connected.
• Inadequate or incorrect electrical
connections can cause electric shock
or fire.
