30 electrolux.com.au
INSTALLATION
(CONTINUED)
Positioning the machine
When considering the location for the dishwasher,
ensure that there is adequate space to enable loading
and unloading of the dishes.
• Do not put your machine in any location where
the ambient temperature can fall below 5°C.
• Before positioning, take the machine out of its
packaging by following the warnings located on
the package.
• Position the machine close to a water tap and
drain. You need to position your machine, taking
into consideration that its connections will not be
altered once they are made.
• Do not grip the machine by its door or panel in
order to move it.
• Take care to leave a certain clearance from all sides
of the machine so that you can comfortably move
it back and forth during cleaning.
• Make sure that the water inlet and outlet hoses do
not get squeezed while positioning the machine.
Also, make sure that the machine does not stand
on the electrical cable. Adjust the machine’s feet
so that it is level and stable. Proper positioning of
the machine ensures problem-free opening and
closing of its door.
• If the door of your machine does not close properly,
check if the machine is stable on the floor; if not,
adjust the feet and ensure it is level and stable.
Water connection
Ensure that the indoor plumbing is suitable for installing
a dishwasher and complies with AS/NZS 3500.1. Also,
we recommend that you fit a filter at the entrance of
your place or apartment so as to avoid any damage
to your machine because of any contamination
(sand, clay, rust etc) that might be
occasionally carried in through the
main’s water supply or the indoor
plumbing, and to avoid problems of
staining and formation of deposits
after washing.
Water inlet hose
Do not use the water inlet hose of
your old machine, you must use
the new water inlet hose supplied with your machine.
Before connecting the water inlet hose to the water
tap, ensure clean water is flowing from the tap before
making the connection. Connect the water inlet hose
directly to the water inlet tap. The pressure supplied by
the tap should be at a minimum of 0.03 MPa and at a
maximum of 1 MPa. If the water pressure is above 1
MPa, a pressure-relief valve should be installed.
WARNING
WARNING
Only turn the locking nut to secure hose –
do not turn the hose.
• The first time you use the appliance, make sure
that there is no leakage.
• The water inlet hose has a safety valve and a
sheath with an inner mains cable.
• After the connections are made, the tap should be
turned on fully and checked for water tightness.
For the safety of your machine, make sure to
always turn off the water inlet tap after each wash
program is finished.
WARNING
WARNING
NOTE: Aquastop inlet hose has
components using 240V. Do not
cut Aquastop inlet hose. Do not let
it get folded, twisted, kinked
or crushed.
WARNING
WARNING
NOTE: A water tempering valve is
required if the water temperature
is over 60°C.
WARNING
CAUTION
Always use new hoses when you connect the
appliance to the water supply. Old hoses must
not be used. The water inlet hose must be
examined at an interval of twelve months for
deterioration and replaced if necessary.
In order to pass the safety valve through the
kitchen cabinets, an opening of at least 45mm x
90mm is needed.
30cm
min.
Summary of Contents for ESF6767KXA
Page 1: ...User manual Dishwasher ESF6767KXA ...
Page 33: ...33 NOTES ...
Page 34: ...34 electrolux com au NOTES ...
