Electrolux EPWC1MEUKG, Instruction Manual

Page: 5 / 16

5
Fixing the appliance on the wall
(optional)
Fix the template on the wall at the desired
height, make sure that it is kept level, and drill
using the appropriate materials.
Place the two bushings and se-
cure the two screws all the way.
Fit the hooks located on the back
of the appliance to the screws,
and check that the product is
fastened and leveled.
Plug the appliance into a dedi-
cated power outlet. Do not use
extension cords or T-type con-
nectors (benjamim). This type
and an overload on the electri-
cal grid impairing the perfor-
mance of your product.
check the condition of the electrical grid at the
appliance site. For details, contact the Electro-
lux Authorized Service.
The wires of the power outlet into which the ap-
pliance will be plugged must be in accordance
with BS1363 type G. Check that the maximum
allowable voltage variation at the installation
site is as shown in the table below. If the supply
voltage of the appliance exceeds the limits indicat
ed in the Allowable Voltage Variation table, ask
the power utility company to adjust the voltage
levels or install a voltage regulator (stabilizer)
with a power of 1000VA or less.
Allowable Voltage Variation
Voltage (V) Minimum (V) Maximum (V)
127 116 133
220-240 201 255
hooks
IMPORTANT
If you wish to use water from artesian or
homemade wells, it is important to have a
report that proves the indication that the
water is drinkable and that it meets the
requirements of drinkability established
by the Ministry of Health. Subsequently,
the water must be chlorinated to preserve
it from possible contamination. The max-
-
imately 2 liters/min while the tank is full.
The temperature of the mains water must
be between 4°C and 38°C and the mains
pressure between 4 and 40 mca (39.2 and
392.26 kPa) for the proper operation of the
product.
Do not put any objects on the product.
ATTENTION
-
ing the installation of the water pipe.
ATTENTION
Water Pipe Installation
• A 1/2" gauge tap is required near the instal-
lation site. The maximum distance between
the product and the tap should be 1.5 m.
• The installation tap must provide drinkable water.
Electrical Installation