8
Prior to first use
In the chapters ”Daytime setting” and ”First heating--up” the
manipulation steps for the electronic oven control are just
briefly described with hints on buttons and symbols: Relevant
explanatory information you will find in the following chapter
”The electronic oven control”:
Daytime setting
The appliance must be switched off when setting or
resetting the daytime. After connection to the power
supply or after a power failure
12 00
will flash for about
5 seconds in the display. Afterwards
12 00
will remain
on and between the indicator for hours and minutes
will flash. The actual daytime between 0.00 - 23.59
hours has to be set.
As long as 12 00 is flashing:
by means of pushing the buttons
and
set the daytime.
With 12.00 already remaining on in the display and with
flashing:
At first do simultaneously push the buttons
(cooking duration) and
(switch--off
time) for about 5 seconds since 12 00 flashes,
then by means of buttons
and
then set
the daytime.
After 5 seconds the time will remain in the display and
is flashing between the indication of hours and minu-
tes. The setting procedure is completed.
In case of corrections of time (Summer/Winter time,
power failure, etc.) proceed in same manner.
First cleaning
To remove any possible production remnants, the ap-
pliance should be cleaned before use.
Remove any possibly existing labels and protective fo-
ils from control panel and oven door.
Clean control panel and oven door with warm water
and a cleanser and dry afterwards.
Remove the accessories from the oven and rinse them.
Clean the oven and the door with warm water and a
cleanser and dry afterwards.
With that the oven light may be switched on:
Push button
(on/off) for switching on
the oven light and for switching off.
