Electrolux EOD67642, User Manual

Page: 51 / 60

electrolux
installation
51
Fitting into the cabinet
IMPORTANT: Ensure that the oven
is switched off at the wall before
any further work is carried out.
•
Using a tape measure establish the
internal width of the cabinet. Refer
to recommended cabinet
dimensions diagram if greater than
565mm.
•
Position the appliance in front of
the cabinet.
Mains cable
•
Take out all oven furniture before
installation to reduce the weight
you need to lift. The oven door
should be taped up to keep it
closed whilst lifting.
•
To place the appliance into the
cabinetry follow the procedure:
Two people will be required to carry
out the lifting procedure.
Warning: Do not attempt to lift this
appliance by the handle(s).
•
Each person should squat either
side of the appliance.
•
Tilt the appliance so that your
hands can support the underside
of the appliance.
•
Keeping your back straight, raise
the appliance to the correct height
by straightening at the knees.
•
Rest the rear underside of the
appliance on the cabinet floor while
your hands support the front.
•
The appliance can be pushed fully
into the cabinet. Take care to
avoid fouling the mains lead.
•
Ensure the appliance is central and
level.
•
Do not remove spacers fitted
behind fixing holes.
•
When the appliance is fully housed
screw the stability screws (supplied
with the appliance) into the side of
the cabinet taking care not to
distort the side trims. It is
advisable to turn each screw
alternatively to avoid damaging the
trims.
Fixing point
for stability
screws
• Switch on the appliance then refer
to the operating instructions.