electrolux
installation instructions
31
Moving your appliance
You may damage some soft or badly
fitted floor coverings when you move
the appliance. The floor covering under
the appliance should be securely fixed
so it does not ruck up when you move
the appliance across it. Alternatively
you could remove the floor covering.
This appliance is heavy and care must
be taken when moving it. Do not try to
move the appliance by pulling the door
handles.
To move the appliance, open the grill
door. Raise the appliance off its front
feet by lifting it from inside the oven.
Pull the appliance forward. When you
replace the appliance push it back to
the stop and make sure there is the
same gap at each rear corner.
For your safety
•
Do not
try to disconnect the
appliance from the gas supply if the
supply pipe does not have a bayonet
connection, as described in the
installation instructions. If this is the
case contact the person who installed
the appliance.
Location of appliance
This appliance must not be installed in
a bed-sitting room of volume less than
20m
3
or in a bathroom, shower room
or garage. It is essential that the
appliance is positioned as shown.
40 min
685 min
Shelves, wall cabinets and cooker
hoods must be fitted a minimum of
mm directly above the top of the
hob (or greater for cooker hoods if
recommended by manufacturers
instructions) and 400mm above the
hob when fitted in line with the outside
of the appliance. If the units are
intended to be fitted adjacent to the
appliance but less than 400mm above
the hob, then a minimum space of 40
mm must be maintained between the
sides of the unit and the appliance.
Curtains must not be fitted
immediately behind the appliance or
within 150mm of the sides of the
hotplate. If fitted next to or between
two base units a minimum space of
1mm must be left between each unit
and the sides of the appliance. The
hotplate must be set to a minimum of
7mm above the adjacent units. (Note:
The leveling feet fitted to the appliance
will achieve a nominal height of 907mm
-5+ 13mm. Base units not meeting the
above conditions must be a minimum
of 100mm away from the hotplate.
685
