Component Teardown
4-17
Drive Belt Removal
The drive belt (6 rib flat Poly-V) is used to transmit power
from the motor pulley to the tub. The belt is constructed
of a material that stretches, which makes belt tension
adjustments unnecessary.
To remove the drive belt:
1. Remove rear access panel.
2. Remove the belt by turning tub drive pulley and
rolling belt off pulley. The belt is elastic and is
designed to “give” enough to remove and install in
this manner. (See Figure 4-48)
Large Pulley Removal
To remove the large pulley:
1. Remove the rear access panel and drive belt.
2. Using a #6 mm allen wrench remove the bolt in
the center of the pulley by holding the pulley and
turning the bolt counter clockwise.
(See Figure 4-49)
Drive Motor Removal
The drive motor is secured with four bolts to the bottom
of the wash tub assembly. The ground wire connects
to a terminal to the front of the drive motor that can be
accessed from the rear access panel.
To remove the drive motor:
1. Remove rear access panel.
2. Remove the drive belt.
3. Disconnect the electrical plug and the ground wire
from the drive motor. (See Figure 4-51)
4. Using a 5/16” socket remove the four bolts, two in
the front and two in the rear, that secure the motor to
the outer tub. (See Figure 4-50)
5. Support the drive motor while pulling forward and
remove from unit.
6. Reverse procedure to reinstall, making sure the belt
tracks in the center of the large pulley. Adjust by
moving belt on motor pulley if required.
Figure 4-48.
Figure 4-49.
Figure 4-50.
Figure 4-51.
6mm Allen
Wrench
5/16” Bolts
1 not shown
Electrical
Connection
Ground Wire
Summary of Contents for EIFLW55H MB
