Electrolux EIFLW55H MB, Technical & Service Manual

Page: 72 / 90

Component Teardown
4-12
Overflow /Vent Tube Removal
The overflow/vent tube connects to the rear of the
detergent dispenser housing and to the overflow/vent
tube grommet at the rear of the unit.
To remove the overflow/vent tube:
1. Remove the top panel.
2. Remove overflow/vent tube grommet.
3. Turn the tube counter clockwise about a 1/16 of a
turn to unlock the tube. Then pull the tube back to
disengage it from the detergent dispenser housing.
(See Figure 4-31)
4. Push the front of the tube down and forward toward
the water inlet valve assembly until the tube clears
the rear panel and remove from unit.
Water Inlet Valve Assembly
The water inlet valve assembly is mounted with three
screws to the back of the detergent
dispenser. The inlets are color coded as well as the
valves and connectors for the wire harness.
To remove the water inlet valve assembly:
1. Disconnect the washer from the hot and cold water
hoses.
2. Remove the top panel, water valve and over
flow/vent tube grommet and the overflow/vent
tube.
3. Disconnect the wiring harness from the valves and
the temperature sensor. (See Figure 4-32)
4. Using a #2 square bit screwdriver, extract the three
screws, one on each side and one underneath the
water inlet valve assembly, securing the water inlet
valve assembly to the detergent dispenser housing.
(See Figure 4-33)
5. Pull back on the valve assembly to disengage it from
the detergent dispenser housing and lift out of unit.
Figure 4-31.
Figure 4-32.
Figure 4-33.
Overflow/ Vent
Tube
Screws
Electrical Connection