35
Changing The Water and Air Filters
Your refrigerator is equipped with separate
water and air filtering systems. The water filter
system filters all dispensed drinking water, as
well as the water used to produce ice. The air
filter removes odors and impurities from the
refrigerator compartment.
Replacement
Water Filter
Remove Two
Protective Caps
Push Water Filter Button
Water Filter
Button
Water Filter
Cartridge
NOTE
The control panel includes controls to
monitor the status of your water and air
filters. See the Controls section for more
information.
About your advanced water filter
The
PureAdvantage
TM
NGFC
2000 ice and water filter system
is tested and certified by NSF
International to NSF/ANSI
Standards 42 and 53 for the
reduction of claims specified on
the performance data sheet.
Water filter
The water filter is located at the lower left side
of the fresh food compartment.
Replacing your PureAdvantage
TM
water filter
In general, you should change the water filter
every six months to ensure the highest possible
water quality. The Water Filter Status light on
the Touch Panel prompts you to replace the
filter after a standard amount of water (400
gallons) has flowed through the system.
If your refrigerator has not been used for a
period of time (during moving for example),
change the filter before reinstalling the
refrigerator.
Do not use with water that is microbiologically
unsafe or of unknown quality without
adequate disinfection before or after the
system. Systems certified for cyst reduction
may be used on disinfected waters that may
contain filterable cysts.
•
Rated Capacity - 400 gallons for
PureAdvantage
TM
ice and water filter
•
Rated service flow - .5 gallons per minute
•
Maximum Rated Pressure - 100 pounds
per square inch
•
Recommended Minimum Operating
Pressure: 30 pounds per square inch
•
Operating Temp.: Min. 33°F, Max. 100°F
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Turn Off the ice maker on the control
panel.
2 Push the filter release button above the
cartridge to disconnect it.
3 Slide the old water filter cartridge straight
out of the housing and discard it.
4 Unpack the new filter cartridge and
remove the two protective caps covering
the inlet and exit of the filter. Slide the
filter gently into the housing until it stops
against the snap-in connector at the
back of the housing.