33
Installation instructions
Safety instructions
The appliance may only be mounted and
electrically connected by trained and authorised
specialised personnel.
The general guidelines for the operation of
electrical appliances, the regulations of the
responsible utility company and the
specifications in this assembly manual are to be
observed.
With regard to fire protection this appliance
complies with EN 60 335-2-6. Only this type of
appliance may be installed with a high cupboard
or wall on one side.
Appliance assembly
The appliance must be disconnected from the
mains power supply during mounting,
dismantling and servicing.
On unpacking the appliance please ensure that it
is intact and check for evidence of transportation
damage. Damaged appliances must not be
mounted or connected.
The supplier and forwarding company must be
notified of any transportation damage
immediately.
The packaging should be disposed of in an
environment-friendly manner.
The required minimum distances to other
appliances (refer to their technical specifications)
in your kitchen must be maintained.
The appliance must not be mounted directly
adjacent to doors or under windows. Windows
opening or bursting open may knock hot cooking
utensils off the hob.
Drawers should not be fitted underneath the hob.
Installation must be such as to ensure protection
against shock.
The kitchen unit in which the appliance is fitted
must satisfy the stability requirements of DIN
68930.
For protection against moisture, all cut surfaces
must be sealed with a suitable sealing material.
On tiled work surfaces, the joints in the area
where the hob is seated must be completely filled
with grout.
On natural, artificial stone or ceramic tops, the
snap action springs must be bonded in place with
a suitable artificial resin or two-component
adhesive.
Check the seal in the support surround for a
perfect fit and continuous contact.
No additional silicone sealing mass must be
applied as this will hinder removal for service
purposes.
To dismantle, the hob must be pressed out from
below.
Clean the worktop around the cut-out area.
Please observe these instructions
otherwise guarantee claims on the
manufacturer will be nullified.