Electrolux EHO 600, Operating And Assembly Instructions Manual

Page: 8 / 10

30
• Cut out worktop to prescribed
measurements of templates (saw
exactly along the scribing).
• Check seal for perfect fit and
overall cover.
• Lower the ceramic hob into place
and align correctly.
Fastening according to Fig. 1
• Tighten bracket against the underside of the worktop.
• Using a standard or Phillips screwdriver, tighten the
tension clamps evenly starting at the centre and
moving diagonally until the built-in rim is tight on the
worktop.
• Do not overtighten!
• Do not use an electric or pneumatic sdrewdriver
without an adjustable safety clutch (pos. 1-1.1 Nm).
The installation of electrical appliances must be
undertaken by qualified electricians only.
Improper repair can cause serious harm and
danger for users.
The protection against accidental contact must
be ensured by proper installation.
• The distance between the underside of the hob and
the furniture beneath must be at least 20mm.
• If the appliance is not connected by a plug, a device
which makes it possible to separate the appliance
at all its terminals from the mains by a contact gap
of at least 3 mm must be superposed.
Attention: • If there are any repairs to be
effected, the appliance must be non-
tensioned .
• If any fissures or cracks appear on
the hob's surface the hob has to be
switched off immediately . Disconnect
the appliance from the mains and inform
the service department.
In terms of fire protection, the appliance conforms
to type Y (IEC 335-2-6). Only appliances of this
type may be installed on one side of adjacent
upright furniture housings or walls.
Important for the removal of the hob
Interrupt the power supply (e.g. by unscrewing the
fuse).
bracket
Sealing Ceramic
Worktop
20
INSTALLATION AND ELECTRICAL CONNECTION