6
3
button — Press this button, you can
select the fan speed as follows:
auto—► hi —► med — low
The fan speed indicator light illuminates
under the different fan speed.
Note:
In fan mode,do not have auto fan
speed;
4- - or - button
a. Each time the + or - button is
pressed, the setting temperature will
increase or decrease by 1 °С (IT). The
setting temperature ranges from 16°C
(60T)~32 °С (90 °F).
b. By pressing both the + and -
button at the same time(>3s), the
display will toggle between Celsius and
Fahrenheit.
5.
button — Press this button, you can
select the running mode as follows:
auto —► cool —► dry—► fan—►heat
Heat-pump type:
auto—►cool—►dry—► fan
Cool only units:
The mode indicator light illuminates under the
different mode.
6.
button — Press this button to enter sleep
mode, which the unit will exit after 8 hours
of continuous operation and restore to the
previous status.
Note:
The SLEEP function can not be activated
in fan and dry mode.
7.
button
a. Press the " " button, the timer indicator
light illuminates.
b. Press + ( ) or - ( ) button to select
the desired time.
c. After setting time 5 seconds without
other operation, the timing function will
be initiated automatically. If you press
the timer button, there are no operation
within 5 seconds or setting time is 0,
the timing function will be cancelled
automatically.
d. When the timing function is initiated, the
unit displays the remaining time by press
the "timer" button once and cancel the
timing function by press it again.
Note:
With the unit on, press this button to set
off timer.
With the unit off, press this button to set on
timer.
8.
button —Press this button, the swing
indicator light will illuminat
WARNING
Failure to follow the below precaution
could result in electrical shock, fire ,
explosion or personal injury.
1. The plug must be plugged into an
individual socket that is properly installed
and grounded.
2. Do not use an extension cord or plug
adaptor with this unit.
Before starting the unit
1. Select a suitable location, make sure the unit
is near to an electrical outlet.
2. Install the flexible exhaust hose and the
adjustable window slider kit.
3. Plug the unit into a right outlet.
Heating operation mode (Cool only unit has
no heating function)
1. Press the MODE button in a sequence until
the heat indicator is lighted.
2. Press the "+"and "-"button to setting your
desired setting temperature.
3. Press FAN button to select the fan speed.
Cooling operation mode
1. Press the MODE button in a sequence until
the cool indicator is lighted.
2. Press the "+"and "-"button to set your
desired setting temperature.
3. Press FAN button to select the fan speed.
Drying operation mode
1. Press the MODE button in a sequence until
the dry indicator is lighted.
2. The fan will run at a fixed speed at this
operation mode.
3. Close windows and doors for the best
dehumidifying effect.
Note:
The setting temperature and fan speed
can not be adjusted.The setting temperature is
25°C (77°F) and the fan speed is low.
Fan operation mode
1. Press MODE button in a sequence until the
fan indicator is lighted.
2. Press the FAN button to select the fan
speed.
Note: The setting temperature can not be
adjusted.
Auto-restart function:
If power to the unit is interrupted, the unit will
restart itself in its last used mode / settings
once power is restored. The compressor will
restart after 4 minutes.
1. Set: Press the sleep button 10 times within 5
seconds, buzzer sounds 4 times.
2. Cancel: Press the sleep button 10 times
within 5 seconds, buzzer sounds 2 times.
