Component Teardown
4-10
Door Disassembly (Continued)
DOOR PANEL ASSEMBLY AND LEFT AND RIGHT
LATCH HEAD REMOVAL
10. Remove the fourteen (14) screws holding the door
panel assembly to the door frame.
11. Remove the door panel assembly from door frame.
12. Remove the one (1) screw holding the latch head R
to the door panel assembly.
13. Remove the latch spring R from the latch head R and
the handle lever.
14. Now, the latch head R is free.
15. Remove the one (1) screw holding the latch head L to
the door panel assembly.
16. Remove the latch spring L from the latch head L and
the handle lever.
17. Now, the latch head L is free.
18. Release the two (2) handle springs from the two (2)
handle
levers.
19. Pull out the two (2) handle pins from the two (2)
handle levers.
20. Remove the two (2) handle levers from the door
panel.
21. Now, the door panel is free.
Control Assembly And CPU Unit
Removal
CONTROL PANEL ASSEMBLY
1. Disconnect the oven power supply cord and remove
outer case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
4. Disconnect the 9-pin & 14-pin harness from the
connectors CN-D and CN-N on the power unit.
5. Remove the four (4) screws holding the control panel
assembly to the oven cavity front plate.
6. Now, the control panel assembly is free.
CPU UNIT
7. Disconnect the 12-pin (CN-S), 6-pin (CN-M) & 10-pin
(CN-L), 16-pin (CN-K) harness from the connectors
on the power unit.
8. Remove the eight (8) screws holding the CPU unit to
the panel sub assembly. See Figure 4-8.
9. Now, the CPU unit is free.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
Figure 4-8. Control Panel and CPU
(8) Screws
Summary of Contents for E30MO75HPS - 1.5 cu. Ft. Drop-Down Door Microwave
Page 2: ......