Electrolux AEG DD9996-B, Operating And Installation Instructions

Page: 14 / 20

14
INSTALLATION INSTRUCTIONS
Wall drilling and bracket fixing
As a first step, proceed with the following drawings:
• a vertical line up to the ceiling or up to the upper
limit, at the centre of the area in which the hood is to
be fitted;
• a horizontal line at a minimum 960 mm above the
cooker top.
• Mark a point ( 1 ) on the horizontal line, 292 mm to
the right of the vertical reference line.
• Repeat this operation on the other side, checking
that the two marks are levelled.
• Mark a reference point ( 2 ) as indicated at 200 mm
from the vertical reference line and 458 mm above
the cooker top.
• Repeat this operation on the other side, checking
that the two marks are levelled.
• Mark a reference point (
3
) at 743 mm above the
cooker top on the vertical reference line.
• Drill at the marked points (
1
), using a ø 12 mm drill
bit.
• Drill at the marked points (
2
) and (
3
), using a ø 8
mm drill bit.
• Insert the bracket plugs
11a
into the holes (
1
) and
tighten the screws.
• Insert plug
11
into holes (
2
) and (
3
).
• Place bracket 7.2.1 on the wall, about 1-2 mm from
the ceiling or from the upper limit, aligning the centre
(notch) with the vertical reference line.
• Mark the wall at the centres of the bracket holes.
• Place the bracket 7.2.1 on the wall at X mm below
the first bracket (X = height of the upper chimney
section), aligning the centre (notch) with the vertical
line.
• Mark the wall at the centres of the bracket holes.
• Drill ø 8 mm holes at all the marked centre points.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the
12a
screws (4,2 x 44,4)
supplied with the hood.
���
�
�
� �
���
��
���
��
���
�
��� ���
���
���
�
���
�����
���
���
���