Technical Support - BSP
20/27
599 73 44-69
Rev. 00
10.
DEMO MODE
The Demo Mode is implemented for demonstrating the functionality of the appliance in show rooms or
shops, on trade fairs etc. without energy consumption behind. The user can find out the complete
functionality of the OUI but for security reason the loads (heating elements) stays off.
10.1
WORKFLOW TO ACTIVATE / DEACTIVATE DEMO MODE
To activate / deactivate the demo mode:
1.
From
OFF_STATE
keep the main switch pressed for at least 5 seconds.
2.
The user interface enters
STAND_BY
for 5sec. and jump back to
OFF_STATE
. Buzzer sounds
(Tone_1)
3.
Then release the main switch and press the combination KEY_MODE
+ KEY_FAVOURITE
for two seconds .
4.
Buzzer sounds (
3 x Tone_1
) and
•
The Demo Mode is active now. Indication of Demo Mode in left upper corner with
Layout_18
and
Icon10_1
.
•
The demo mode is deactivated now. No indication of Icon10
_1.
11.
SERVICE MODE (FACTORY TEST)
The factory test is implemented to check all electrical components of the appliance at the end of the
production line. This test can only be activated as long as manufacture logo is displayed.
This function can also be used by the Service for troubleshooting.
11.1
SERVICE MODE ACTIVATION
Activation will be done by pressing KEY_HOME
+ KEY_MODE
simultaneous for 2seconds until
the buzzer sounds (Tone_1). After activation of the factory test the display starts with the first activated loads
of main cavity.
11.2
SERVICE MODE DEACTIVATION
Pressing the KEY_MAIN
together with another key you can terminate the factory test.
The factory test should be deactivated after 5 minutes without any user interactions
If the factory test was done, the user can deactivate the factory test with the KEY_MAIN
. After that the
oven has to be disconnected from the mains.
