Technical Support - A.D.L.
82/83
599 74 12-51 Rev.00
13.27 Remove the washing unit.
•
Remove the 2 left and right sides.
•
Cut and remove the lower cutting ring on the bellow.
•
Release the bellow from the lower side.
•
If there is a spray pipe, slacken the clamp, release the
clamp that holds it to the tub and remove it.
•
Slide off the belt and remove the pulley.
•
Remove the DSP drum positioning device.
•
Remove the two left and right counterweights.
•
Remove the heating element.
•
Remove the drum rotating motor.
•
Slacken the pipe tightening clamp in the flexible pipe
and remove it.
•
Disconnect the pressure switch and release the pipe
on its entire route.
•
Release the shock absorber pivots from the washing
unit side.
•
Release all the washing unit’s support springs.
•
Rotate the washing unit and remove it by pulling it to
one side of the equipment.
