• The appliance can be installed separately or combined only with other
appliances of the same range.
• The appliances are not suitable for recess-mounting. Leave a space of
at least 100 mm between the appliance and side walls and 100 mm
from the rear wall, or in any case an adequate space to enable
subsequent servicing or maintenance operations.
• Suitably insulate surfaces that are at distances less than that indicated.
• Maintain a distance of at least 250 mm between the appliance and any
combustible walls. Do not store or use flammable materials and liquids
near the appliance.
• Check and, if necessary, level the appliance after positioning. Incorrect
levelling can cause appliance malfunctioning.
• Wear protective gloves and unpack the machine, carrying out the
following operations:
– cut the straps and remove the protective film, taking care not to
scratch the surface if scissors or blades are used;
– remove the cardboard top, the polystyrene corners and the vertical
protection pieces;
– for appliances with stainless steel cabinet, remove the protective
film very slowly without tearing it, to avoid leaving glue stuck to the
surface;
– should this happen, remove the traces of glue with a non-corrosive
solvent, rinsing it off and drying thoroughly;
– go over all stainless steel surfaces vigorously with a cloth moistened
with paraffin oil in order to create a protective film.
• In case of permanent connection: the device lockable in the open
position must be accessible even after the appliance is installed in its
place.
A
A..1
10
0 R
Re
ea
asso
on
na
ab
bllyy ffo
orre
esse
ee
ea
ab
blle
e iim
mp
prro
op
pe
err u
usse
e
Improper use is any use different from that specified in this manual.
During machine operation, other types of work or activities deemed
improper and that in general can involve risks for the safety of operators
and damage to the appliance are not allowed. Reasonably foreseeable
improper use includes:
• lack of machine maintenance, cleaning and periodical checks;
• structural changes or modifications to the operating logic;
• tampering with the guards or safety devices;
• failure to use personal protection equipment by operators, specialised
personnel and maintenance personnel;
11
