11
Stopping or interrupting a self-cleaning cycle
91
To start the delayed self-clean cycle
92
To set the control for the self-cleaning cycle to
start at a delayed time and shut off automatically
92
When the self-clean cycle is completed
92
Adjusting oven temperature
93
To adjust oven temperature
93
Failure modes
93
How the PRC Glass touch electronic oven control works
94
Capacitance touch glass
94
Preheat
94
Bake
94
Timed bake
94
Convection bake
94
Convection roast
94
Broil
94
Clean
95
Calibration
95
To check oven calibration
95
To change the calibration
95
To adjust the oven temperature lower
95
Troubleshooting
95
F1 code
95
F3 code
95
F9 code
96
Control will not program
96
Time bake does not operate
96
Convection bake
96
Fan motor does not operate
96
Convection element does not heat
96
Control does not operate in preheat
96
Blank display
96
Bake element does not heat
96
Broil element does not heat
96
Oven door does not lock when the oven
is programmed for clean
97
Oven door locks but the oven does not heat
97
Door latch is partly closed with door open
97
Sample schematic for PRC Glass touch control system
98
Warmer drawer
99
To set the warmer drawer thermostat control
99
How the warmer drawer circuit works
99
Troubleshooting
99
If the element does not heat
99
If the element heats during preheat, then stays
off until the temperature drops to about 130° F
100
If the element does not cycle off
100
If the warmer drawer is slow preheating
100
If the warmer drawer heats, but the
indicator light does not glow
100
SECTION E - 30” DISASSEMBLY AND REPLACEMENT OF PARTS
101 - 122
Top trim on backguard area
101
Removing the 15 amp fuse
101
Removing the fluorescent lamp starter
101
To roll the control mounting panel forward
101
Removing the 120 volt outlet
101
Removing the oven light or fluorescent switch
102
Summary of Contents for 30" Electric/Microwave Combination Wall Oven
