64
Removing the press saver option switch: (Front
console models)
1. Disconnect the dryer from electrical supply.
2. Remove the press saver option sw. knob, lift the top,
disengage the front panel and lean it forward.
3. Disconnect the wires from press saver option sw.
4. The switch is held to the control mounting by a
spring loaded nut and a locking tab.
5. Using a small screwdriver push in on the locking
tab and turn the switch one half turn and pull it out
the rear.
Removing the end of cycle chime switch: (Front
console models)
1. Disconnect the dryer from electrical supply.
2. Lift the top, disengage the front panel and lean it
forward.
3. Disconnect the wires from the end of cycle chime
sw.
4. Squeeze the tabs on the side of the switch and
push the switch out the front.
Removing the electronic moisture sensor control:
(Top console models)
1. Disconnect the dryer from electrical supply.
2. Remove the back panel from the console and
unplug the harness from the electronic moisture
sensor control.
3. Push up on the top tab to release the control.
Tab
Locking tab
Nut
