22
3. Shift the appliance onto the transport pallet such that all of
the installation connections lie within the appliance.
4. Tip the appliance until it is standing on the floor. Then lift at
the front and remove the transport pallet.
5. Carefully lower the appliance and then move it into the
correct position.
6. Remove the outer protective film and the edge covers,
taking care not to scratch the surface of the appliance.
Very slowly pull off the protective film on the stainless steel
surfaces, without ripping, to prevent any adhesive residue.
Remove any adhesive residue with a non-corrosive solvent.
Then rinse and dry the spot thoroughly.
G.4.4
Securing or adjusting to the floor (optional)
If you need to secure it to the floor, the appliance comes with compatible adjustable feet.
We recommend you adjust the feet so you end up with a working height of 900 mm / 35,43″. Level the unit with a spirit level.
Attaching the unit with screws
The feet have metal plates which may be secured to the floor
using screws .
Attaching the unit by welding
The metal plate underneath the feet must be welded to the
floor with a continuous weld around the outer edge.
100 - 200 mm
3,94 - 7,87“
1
100 - 200 mm
3,94 - 7,87“
2
