16
Installation manual
7.1
Connecting an external payment system
Note!
Can only be used on premium products.
Loosen the two screws (Torx T20) on the underside of the front panel, square hole in the frame. Slide the front panel
upwards until it detaches from the guide flanges. Then remove it.
fig.W01240
Connect the cables of the external payment system to the connections (A). If run information is needed, it is found on
the two pin contacts on the right (Aa).
A: requires potential-free switch. In other words, the signal comes from the card and must not receive any more
voltage.
Aa: is a potential-free relay that can handle 250 VAC.
Aa
A
1
1
2
1 2
2 3 4
1 2 3
1 2 3
4
5 6 7
4 5 6
8
fig.W01247