Sec tion 1 - Quick Set-Up
Quick Set-up: Re ceiver
1.
Do not con nect the re ceiver to any other equip ment yet!
2.
Con nect the two An ten nas to the re ceiver.
3.
Plug the power cord into the back of the re ceiver and into
an out let.
4.
Press the Power switch. Dis play will light up, show EV
name and soft
ware re
vi
sion num
bers for about 3 sec
-
onds and then dis play the main op er at ing screen.
5.
Press the MENU but ton twice to dis play the MENU op tion
screen and then press set.
6.
With the CLEARSCAN ALL line highlighted, press SET.
7.
ClearScan
TM
re
turns the clear
est group. Press SET
again.
8.
ClearScan
re
turns the clear
est chan
nel in that group.
Press SET again.
9.
The dis play will re turn to the main op er at ing screen with
the clear est chan nel in the clear est group as signed.
10.
Turn the re ceiver off and con nect the mixer or other au -
dio sys tem to the re ceiver XLR Mic/Line Level Con nec tor
or the ¼ inch Line Level Jack.
11.
Set the au dio mixer or other sys tem in put level to min i -
mum.
12.
Turn re ceiver back on
Re ceiver “Quick Set-up” is com plete.
Quick set-up: Trans mit ter
1.
With the Power switch on the trans mit ter OFF, in stall a
fresh Bat tery (9V or two AA) into the trans mit ter.
2.
Place the trans mit ter Power Switch to the ON po si tion.
3.
The LCD dis
play backlight will come on and dis
play
Group and Chan nel and bat tery level.
4.
Press the SET but ton once and the Group num ber will
flash.
5.
Use the up and down ar rows to change the Group num -
ber to match the chan nel num ber dis played on the re -
ceiver. Press SET and the Chan nel Num ber will flash.
6.
Use the up and down ar row but tons to change the Chan -
nel to match the re ceiver. Press Set and noth ing will be
flash ing, the chan nel is now set.
7.
If you are us ing a bodypack trans mit ter, plug the mi cro -
phone into the trans mit ter con nec tor. If us ing a gui tar, put
the bodypack and re
ceiver into in
stru
ment mode (see
page 5, Part K and page 13, Part G).
Trans mit ter “Quick Set-up” is com plete.
Quick set-up: Sys tem Op er a tion
1.
With the trans
mit
ter and re
ceiver on, mon
i
tor the REV
Re ceiver main dis play screen. Note that the RF (1-100)
Bar graph should in di cate near the 100 mark. The AF Bar
should show very lit tle if any, in di ca tion un til you talk or
sing into the mi cro phone.
2.
On the trans mit ter, press Set and Down but tons at the
same time twice to ac cess the gain ad just ment mode.
3.
Press set and use the Up and Down but tons to ad just the
trans mit ter gain to cause the AF Bar Graph to peak be -
tween 50 and 100 for best per for mance.
4.
Set the mixer/amp gain.
5.
Talk or sing into the mi cro phone or play the gui tar at a
nor mal vol ume. You should hear au dio com ing out of the
sys tem.
6.
If you are not get
ting enough level at the in
put of the
mixer, see the au dio out put gain ad just ment sec tion on
page 5.
"Quick Set-up" is now com plete. Please en joy your
REV sys tem.
-1-
