4
Q
UICK
S
TART
G
UIDE
PLUGGING IN THE OCEANS 12
1.
Connect the supplied EHX9.6DC AC Adapter into the 9V jack at the
top of the Oceans 12. Plug the AC Adapter into an AC outlet.
2.
Connect your guitar or other instrument into the L IN jack using a
standard 1/4” instrument cable.
Connect the L OUT jack to your amp
with another standard 1/4” instrument cable.
3.
For stereo operation, connect R OUT to another amp.
DIALING IN A STANDARD REVERB EFFECT
1.
Ensure none of the buttons at the top left of the Oceans 12, like TAILS,
are lit. If any of the buttons are lit or blinking, press the button once
to disable it.
2.
Ensure that REVERB A is selected by confirming that its SELECT LED
is lit. This LED is located in the center of the unit, in the section labeled
SELECT. If the SELECT LED of REVERB B is lit, press the small white
SELECT button to toggle reverb selection back to REVERB A.
3.
Turn on REVERB A by pressing its footswitch located on the bottom
left of the Oceans 12. The white bypass LED should turn on.
4.
Rotate the REVERB TYPE knob clockwise to the ROOM setting for a
standard reverb, if not already selected.
5.
Set the two smaller knobs to the right of the REVERB TYPE knob to
their middle positions.
6.
Set the decay time with the TIME knob, the tone with the TONE knob,
the predelay time with the PREDELAY knob, and the reverb volume
with the FX LVL knob.
CHOOSING A REVERB TYPE
1.
Rotate the REVERB TYPE knob in either direction until the desired
REVERB TYPE LED is lit.
2.
Check the table on the Oceans 12 below the mini knobs to see the
corresponding parameters that can be adjusted for the chosen Reverb
Type. Turn the mini knobs to experiment with different reverb effects.